Technological system self-tuning when milling

Technological system self-tuning when milling

Blog Article

This paper reports the dynamics of the technological system during the milling of complex parts and the investigations of possibility in efficiency increase of Spoons a cutting process at the expense of conditions creation for a system self-tuning at which a general level of oscillations will not decrease in it.This can be achieved with a special damping device located on the machine screw gears supports.In this Hemp Wicks case, if the period of the wave on the cutting surface does not coincide with the period of natural oscillations, then there will be no resonance, and the level of oscillations will be much smaller.